Alarmanlagen-Forum - Alarmforum - Fachforum für Sicherheitstechnik

Hi,

My Scantronic R7500 cannot detect my three Pir 714R sensors?

[attachment=906]

Jamming is set to off.

The batteries are new.

I activate the sabotage function by opening the lid of the sensor
I have also tried pushing the tamper/sabotage button

[attachment=907]

What can be the issue.

You can answer in German also :-)

Hi Roarslot,

if the former Batterie longer was empty, you may put off the new battery and connect the + and - from your PIR with a wire or another metall.
Then try it again.

best regards

megagramm

Hi megagramm,

Thank you for your answer.

I tried to short circuit the plus and minus in the PIR sensors, but no luck.

Best Regards

Roar Slot

Hi,

wenn you put the new battery in, ist the red LED blinking?

try to push the sabotage button for a few seconds an several times.

best regards

megagramm

Hi,

Yes, led is blinking red. But the R7500 does not detect them, still.

I have tried pushing the sabotage button several time for all three sensors, but no luck.

Best Regards

Roar Slot

Hi,

try to delete the PIR on your R7500 completly.
Then try again to learn it on your R7500.

best regards

megagramm

Hi,

That I did from the beginning.

Best Regards

Roar Slot