terxon mx + gsm abus module AZWG10020

[Manfredo]

Hi fillemon,
I try to answer by just referring to your numbers, ok ?

1 - yes, any cable will do
2 - yes
3 - yes
3a - yes if 12 V & gnd comes from the MX, but careful : the 4 outputs are capable of serving 100 mA each + GSM = close to 500 mA !
If preferred external power supply, 9 wire , 1 gnd + 8 signals
4 - ok
4a - right
4a1 - level, not flanks. yes
4a2) - as long as the alarm persists. Siren is max. limited to 3 minutes in Germany
4a3) - yes
4a4) - no. in general, it’s up to you to deal with high or low level at the MX and GSM. But there should be no second message by changing the level no matter in which direction.
4a5) - yes
5) - yes
6) - not directly, but using one of the 4 GSM output to trigger a zone of the MX coded as a entrance key - should work
6a) - yes, see 6)
6b) - any
6d) - how about a tiny reed relay hooked to the GSM output 1 - 4 ?
6e) no, at least 2.5, better 3 seconds
6f) - how about 11 (SS) ?
6g) - what security on the phone or net grid ?? there is N-O-N-E anymore !!
a) - I haven’t seen this option reading trough the PDF for you (haha ...)

Regards
Manfred